Peculiarities of technological design of u-shaped screw transport and technological working bodies
Article Sidebar
Main Article Content
Abstract
New methods of manufacturing U-shaped screw transport and technological working bodies (STTWBs) are considered in this paper, in particular, by stamping and winding a sheet with U-shaped indentations on a frame using a wedge; a solid forming shaft and a forming shaft with U-shaped indentations; execution of U-shaped indentations on the pipe blank; winding STTWBs U-shaped profile using rectangular blanks. The main factors that affect the technological design of U-shaped STTWBs and the requirements for them are found. The most suitable structural materials for manufacturing U-shaped STTWBs, the related materials (lubricants), and press equipment are proposed. The technological features of the design parameters of STTWBs made in different ways are also determined
Article Details
Issue
Section
This work is licensed under a Creative Commons Attribution 4.0 International License.
References
1. Development of mechanical engineering in Ukraine: problems and ways to solve them: monograph, State University “Institute of Regional Studies named after M. I. Dolishnyi National Academy of Sciences of Ukraine”; Science editor, Doctor of Economics Science, Prof. S. O. Ishchuk. Lviv, 2022, 137 p.
2. Ocheri C. The role of foundries in spare parts production and economics development of nigeria using ajaokuta steel company as a case study. International Journal of Innovative Studies in Sciences and Engineering Technology. 2020, 6 (7), pp. 38–44.
3. Popovych V., Popovych V. Technology of structural materials and materials science: textbook for students. Technical special higher education closing. Lviv, Svit, 2006. 624 p.
4. Types of casting defects. Electronic edition – Mode of access: https://studfile.net/preview/10102566/page:2/.
5. Stoian E. V., Bratu V., Enescu C. M, Rusanescu C. O. Analysis of internal defects appeared in the continuous casting. Scientific Bulletin of Valahia University. Materials and Mechanics, 16 (14), pp. 23–27 https://doi.org/10.1515/bsmm-2018-0005
6. Blair M., Monroe R., Beckermann C., Hardin R., Carlson K., Monroe C. Predicting the occurrence and effects of defects in castings. The J. Minerals. Metals and Materials Society, 2005, 57, p. 29–34. https://doi.org/10.1007/s11837-005-0092-3
7. Kalandyk B., Głownia J. Wady wtórnego zazuzlenia na przemysłowych odlewach ze staliwa, Archiwum Odlewnictwa, 2007, 6 (22), pp. 254–259.
8. Kalandyk B., Zapała R., Rakowska A. Characteristics of defects present in industrial steel castings due to metal-mould reactions. Archives of metallurgy and materials, 2009, 54 (2), pp. 289–297.
9. Achamyeleh A. Kassie, Samuel B. Assfaw. Minimization of casting defects. IOSR Journal of Engineering, 2013, 3 (5), pp. 31–38. https://doi.org/10.9790/3021-03513138